ZAXWERKS: Zaxwerks Forum Zaxwerks Tutorials

creating a certain type of Bevel in Invigorator

COW Forums : Zaxwerks

<< PREVIOUS   •   VIEW ALL   •   PRINT   •   NEXT >>
LIZZY CROSS
creating a certain type of Bevel in Invigorator
on Jan 16, 2008 at 8:06:50 pm

Hi there, I have a what sounds like a very stupid question........
I need to create a certain bevel on a logo in Invigorator.
this sounds like a very simple thing to do but for some reason is proving extremely difficult. The bevel should have no flat front face but go to a pointed edge.
Here is a link to the website with the logo as it should look.

http://www.19.co.uk/

I have a very tight deadline for this job and was hoping that someone may know how this is done in Invigorator. I am trying Cinema 4D aswell to but to no avail.

Thank you in advance, Lizzy


Return to posts index

Jon Okerstrom
Re: creating a certain type of Bevel in Invigorator
on Jan 17, 2008 at 1:09:05 am

Hi Lizzy,

Are you talking about the circle 19? The trick is to make the front face very narrow and/or use the edge offset to make it essentially disappear.

Jon



Return to posts index

LIZZY CROSS
Re: creating a certain type of Bevel in Invigorator
on Jan 17, 2008 at 8:48:19 am

Hi Jon,
I'll give that a go, thank you for your reply.
All the best, Lizzy

PS - sorry, yes I was talking about the circle 19.



Return to posts index

<< PREVIOUS   •   VIEW ALL   •   PRINT   •   NEXT >>
© 2017 CreativeCOW.net All Rights Reserved
[TOP]