Hey everyone, having a little issue here that's a bit of an annoyance. I'll try to explain best I can.
So I basically have been doing "Render and replace" with the audio in my project, swapping between Premiere and Audition, and one issue I'm running into is that after I apply a noise removal effect to the audio and play it back, it seems the effect doesn't become "active" until a second or so after the audio plays instead of being applied to the entire clip.
This causes a sort of rollercoaster effect where the noise is jumping in and out of the playback from the between points of where the clips are cut.
Sorry if it wasn't as clear as I'd like it to be. I've tried all of the solutions here - http://forums.creativecow.net/thread/3/952899 to no avail. It just seems the only answer is really shifty work arounds and I'm hoping I'm wrong.