Clone Stamp edges issue
by Ran Yad Shalom on Oct 12, 2013 at 9:36:59 pm
Hey everyone, I was looking fo a solution all over the web but couldn't find one.
I'm using the Clone Stamp tool in order to remove wires from my video, the problem is that when I reach the edges of the cloned video with the clone brush, I get these unwanted hard edges and I am unable to continue painting.
The problem could be solved if I could mirror the edges (just like the Motion Tile effect enables to do) but the Clone Stamp brush just wouldn't react to the expanded edges generated by the Motion Tile effect.
so, how can I make this happen?
For most of the project I used the CC wire removal, but it just wouldn't do the trick and this one
Re: Clone Stamp edges issue by Walter Soyka on Oct 14, 2013 at 2:47:19 pm
You could create a wider precomp, then paint on that precomp layer in a standard-width comp.
Principal & Designer at Keen Live
Motion Graphics, Widescreen Events, Presentation Design, and Consulting RenderBreak Blog - What I'm thinking when my workstation's thinking
Creative Cow Forum Host: Live & Stage Events