MAXON CINEMA 4D: Cinema 4D Forum Adobe After Effects Forum

Extrusion is Jumping between X and Y axis when extruding a polygon edge

COW Forums : Maxon Cinema 4D

<< PREVIOUS   •   VIEW ALL   •   PRINT   •   NEXT >>
Matiss Jansons
Extrusion is Jumping between X and Y axis when extruding a polygon edge
on Jun 11, 2020 at 7:52:50 am

Hi,

I'm having a real hard time trying to figure out why whenever I try to extrude an edge of a polygon, it constantly changes the direction across x and y axes.
Is there a way to make it work on a single plane?

Here's a screenshot of the problem.


I would just need the extrusion to happen on one plane.

Your help is much appreciated!

Thanks!


Matiss


Return to posts index

Jim Scott
Re: Extrusion is Jumping between X and Y axis when extruding a polygon edge
on Jun 11, 2020 at 7:55:39 pm

Make sure the "Edge Angle" is set to 0°. If the angle is set to 90° that will cause the behavior you describe. You may have inadvertently held the shift key after starting to drag, which allows that angle to be changed.



Return to posts index

Matiss Jansons
Re: Extrusion is Jumping between X and Y axis when extruding a polygon edge
on Jun 12, 2020 at 5:57:21 am

Omg, as always, it ends up being such a simple solution!

Thanks a lot Jim!


Return to posts index


Jim Scott
Re: Extrusion is Jumping between X and Y axis when extruding a polygon edge
on Jun 12, 2020 at 6:20:00 am

Glad I could help.


Return to posts index

<< PREVIOUS   •   VIEW ALL   •   PRINT   •   NEXT >>
© 2020 CreativeCOW.net All Rights Reserved
[TOP]