MAXON CINEMA 4D: Cinema 4D Forum Adobe After Effects Forum

Modeling Question

COW Forums : Maxon Cinema 4D

<< PREVIOUS   •   VIEW ALL   •   PRINT   •   NEXT >>
Pravin ChotteraModeling Question
by on Jan 22, 2015 at 6:05:36 am
Last Edited By Pravin Chottera on Jan 22, 2015 at 1:45:42 pm

Hi all,

I can't seem to figure out how to model the object below.



I could try doing some hypernurbs modeling, but is there a way to do it with deformers?

As always, appreciate everyones help. Thanks all!


Return to posts index

Adam TrachtenbergRe: Modeling Question
by on Jan 24, 2015 at 4:51:06 am

If you're using R16 I would use the new "preserve curvature" function of the Slide Tool. This video should be self explanatory, except when sliding the edge loops you need to hold down Ctrl/Cmnd while dragging to create new loops.







If you're not using R16 I would probably create a cube primitive with sufficient Y subdivisions and make it editable. Then I'd create a spline curve to use as a guide and use spline snapping to move the front points to the desired shape.


Return to posts index

Adam TrachtenbergRe: Modeling Question
by on Jan 24, 2015 at 4:40:45 pm

Here's a version of the video tut with better production values. :)







Return to posts index


Brian JonesRe: Modeling Question
by on Jan 24, 2015 at 10:00:21 pm

Soft Selection in scale is good too.




Return to posts index

<< PREVIOUS   •   VIEW ALL   •   PRINT   •   NEXT >>
© 2017 CreativeCOW.net All Rights Reserved
[TOP]