MAXON CINEMA 4D: Cinema 4D Forum Adobe After Effects Forum

Custom Logo

COW Forums : Maxon Cinema 4D

<< PREVIOUS   •   VIEW ALL   •   PRINT   •   NEXT >>
Chuck ObernesserCustom Logo
by on Jun 20, 2011 at 12:23:25 am

Hey all,
Real quick here. I am making a custom logo 3d and I drew out the logo using the b-spline tool. The thing is the logo has "B" "a" and "e". I am have finished drawing out the logo, but I can't boole out the center pieces for the letter mentioned. I have extruded the letter's then drew out the middle with the same tool and extruded that as well. I then drop the boole option in but I am not getting anything to happen. Any ideas?

Thanks,
Chuck


Return to posts index

randy johnsonRe: Custom Logo
by on Jun 20, 2011 at 6:54:33 am

If you connect the splines that make the letter it will work.
/Randy


Return to posts index

Chuck ObernesserRe: Custom Logo
by on Jun 20, 2011 at 3:18:54 pm

Randy,
Thanks so much. An extremely easy task that shamefully took me two hours to really figure out. But it all worked out in the end. Now I just need some aspirin from hitting my head on the desk once I realized how simple the task was.

Thanks again
Chuck


Return to posts index

<< PREVIOUS   •   VIEW ALL   •   PRINT   •   NEXT >>
© 2017 CreativeCOW.net All Rights Reserved
[TOP]