Problem with text
by capsat on Dec 15, 2006 at 9:04:10 pm
I was asked to make a logo with an specific font: Hanshand (http://www.dafont.com/hanshand.font) And when I convert the name (which has a capital X in it) to an editable poly or editable mesh the X disappears... I don't know why this is happening.. I would appreciate any help
Re: Problem with text by Colin Thomson on Dec 20, 2006 at 12:36:33 pm
Some fonts for some reason do that, and the only conclusion I've come to is. 1.) Choose another font that works 2.) Re-draw: Spline/CV Curve outline the letters, then extrude/bevel your letters with in 3ds max. I know that sounds nuts but! Hope this helps .....
Re: Problem with text by capsat on Dec 20, 2006 at 2:59:04 pm
Ok, Thanks for the advise, I just thought it may be a problem with my machine, I even downloaded 3DS Max 9 trial to check that out but the same problem persisted; and well I finished redrawing the X with lines... It didn't finish quite as well as the original one, mainly because the font is to