APPLE FINAL CUT PRO: FCP Legacy FCPX FCPX Techniques FCP Tutorials Basics Forum Podcast

Re: Deinterlacing through compressor results in striped stills.

COW Forums : Apple Final Cut Pro Legacy

Respond to this post   •   Return to posts index   •   Read entire thread

Josh AderholdRe: Deinterlacing through compressor results in striped stills.
by on Jan 22, 2010 at 5:36:01 pm

I've set it to better, but that's the best I can do without Compressor either A. freezing up or B. taking a ridiculously long time.

Could a filter within FCP possibly fix the problem? Doing anything specific to the image? Certain files it might work best with? If I wasn't getting such a horrible result from "Same as Source" I'd just go with that. But I've actually got complaints from my client on the quality after following the normal procedures for exporting through Compressor. And I've seen the results, not so good.

Now this is something that irks me as well. I'm working on another project where the typical route of exporting through compressor worked just fine.

8-bit project (HVX-200)

10-bit project (HDCAM)

My first project there, I didn't even turn on Frame Controls, I just left it to auto and the result was fine. Where as with my 10-bit project, I follow the same procedure and it's artifact city.

Can you possibly shed some light on why this would be?

MacBook Pro
Intel Core 2 Duo
L2 Cache: 6MB
4GB Memory
Bus Speed 800MHz

Posts IndexRead Thread 

Current Message Thread:

© 2016 All Rights Reserved