ZAXWERKS: Zaxwerks Forum Zaxwerks Tutorials

Re: Lathe object "holes"

COW Forums : Zaxwerks

VIEW ALL   •   ADD A NEW POST   •   PRINT
Respond to this post   •   Return to posts index   •   Read entire thread


Edward Wu
Re: Lathe object "holes"
on Dec 10, 2013 at 3:21:19 am

Hi Liam,

If you are wanting to punch a hole in the Lathe object (like cutting a shape and pasting in the lathe path in the drawing window), then there's currently no way of doing that. However, if you are trying to create a hole like a donut, what you can do is pull the path away from the Y-Axis in the drawing window. By pulling the path away from the axis, it will create a hole in the center of the lathe object. The lathe object revolves around the Y-Axis, so if the path is not touching the Y-Axis, it will create a hole in the center.

Hope this helps.

Best,
Edward


Posts IndexRead Thread 


Current Message Thread:
  • Lathe object "holes" by Liam Stirland on Dec 5, 2013 at 4:10:25 pm
    • Re: Lathe object "holes" by Edward Wu on Dec 10, 2013 at 3:21:19 am





© 2020 CreativeCOW.net All Rights Reserved
[TOP]