FORUMS: list search recent posts

Re: stand alone

COW Forums : AJA Video Systems

VIEW ALL   •   ADD A NEW POST   •   PRINT
Respond to this post   •   Return to posts index   •   Read entire thread


VideoManSF
Re: stand alone
on Aug 9, 2005 at 3:54:09 pm

I have done this to transcoder all of my BetaSP to Dbeta to embed audio to SDI, but I used my old G4 500MHz laptop to control the io. I do not think that you'd have to remove the io's drivers though. Also you could do this the easy way:

configure the io via the control panel how you would like it, say Svideo and analog 1-2 to SDI embedded. Then disconnect the firewire cable from the io. the io will stay set to the last settings until you power it off and on. Then capture using the io as a non controlled converter box. I have been doing this for about 18 months now, and have had no problems, long before the control panel app. The same works from FCP, just set up the io with the preset you need and then open log and captuer, and unplug the firewire from the io.

Presto, no need to run the control panel at the same time.

VM


Posts IndexRead Thread 


Current Message Thread:
  • stand alone by Mark Cookman on Aug 5, 2005 at 8:59:13 pm
    • Re: stand alone by VideoManSF on Aug 9, 2005 at 3:54:09 pm
    • Re: stand alone by AJA Sales Department on Aug 9, 2005 at 4:06:08 pm





© 2019 CreativeCOW.net All Rights Reserved
[TOP]