FORUMS: list search recent posts

Re: Timecode Distribution

COW Forums : Audio Professionals

VIEW ALL   •   ADD A NEW POST   •   PRINT
Respond to this post   •   Return to posts index   •   Read entire thread


Daniel de Homont
Re: Timecode Distribution
on Feb 8, 2012 at 3:26:03 pm

According to this document:
http://diallers.com/timecode/5010%20Schematics.pdf

Time Code Outputs:
Each of the two time code outputs will drive a balanced
600 ohm line, providing a nominal level of +11 dBm.
Each output also may be used as 2 unbalanced outputs,
in which case they should be terminated with a 300 ohm
resistor to ground. It is not necessary to terminate
unused output pins. The required mating connectors
are Switchcraft A3F or equivalent. Pin 1 is ground and
the signal is on pins 2 and 3.

So, how much are "multiple" cameras/iso decks?
According to the above you could feed 4 devices/daisy chains.
Can the cameras loop the timecode signal through?
But probably, to remain wireless, you either sync all one in a while, or go for an ambient clockit system.


Posts IndexRead Thread 


Current Message Thread:
  • Timecode Distribution by Paul Rozon on Feb 2, 2012 at 7:01:55 pm
    • Re: Timecode Distribution by Daniel de Homont on Feb 8, 2012 at 3:26:03 pm





© 2020 CreativeCOW.net All Rights Reserved
[TOP]