FORUMS: list search recent posts

Re: Really bad Interference with Sennheiser EW100 G3

COW Forums : Audio Professionals

VIEW ALL   •   ADD A NEW POST   •   PRINT
Respond to this post   •   Return to posts index   •   Read entire thread


Brian Reynolds
Re: Really bad Interference with Sennheiser EW100 G3
on Nov 3, 2011 at 8:50:00 pm

Its a simple process and only takes a few minutes...

1. Turn on RX 1 (but NOT the TX).. do a scan it will then come up with some suitable frequencies available. Set the RX to one of those.

2. Turn on TX 1 and set the frequency to the same as RX 1.

Leave the TX 1 turned on and then repeat the process for unit 2 (then 3), (then 4), (then 5) etc.

By adding each unit in this way and leaving them turned on after tuning it blocks out these used frequencies for the next unit therefore you eliminate interference between units, after 4-5 units you need to get a bit more involved in frequency selection because of harmonic problems.


Posts IndexRead Thread 


Current Message Thread:





© 2019 CreativeCOW.net All Rights Reserved
[TOP]