FORUMS: list search recent posts

Re: Yosemite/Resolve/JL Cooper panels

COW Forums : DaVinci Resolve

Respond to this post   •   Return to posts index   •   Read entire thread

Tristan Kneschke
Re: Yosemite/Resolve/JL Cooper panels
on Dec 3, 2015 at 7:33:44 pm

Here's what I got from BMD to get it working:

Resolve needs to communicate directly with the Eclipse CX. With this in mind, remove the Eclipse Software if it’s installed and reboot. You should now be able to connect to the Eclipse.

If you have the Eclipse CX directly connected to the computer, make sure of the following:

1. The network configuration of the computer is set to ‘Manual’,
2. Set the IP address of the computer different than the IP address of the Eclipse CX.
3. Configure Resolve with the IP address of the Eclipse CX.

For example,
If the Eclipse CX is set to then set the computer to and configure Resolve to find the Eclipse CX at

The IP numbers are arbitrary as long as they are compatible with each other.

If you use a subnet mask of, that means that the first three numbers must match otherwise, the computer or Eclipse will ignore the Ethernet traffic. Thats why both devices start with

When you use DHCP (automatic) settings, the computer will get its settings from the router. If no router is present, the computer will self assign an address like

Because the first three numbers don’t match between the Eclipse ( and the computer (, they won’t be able to communicate with each other.

Posts IndexRead Thread 

Current Message Thread:

© 2020 All Rights Reserved