FORUMS: list search recent posts

Mixer to SRC2496 to ATEM

COW Forums : Blackmagic Design

VIEW ALL   •   ADD A NEW POST   •   PRINT
Respond to this post   •   Return to posts index   •   Read entire thread


Dave Edwards
Mixer to SRC2496 to ATEM
on Sep 21, 2013 at 12:32:33 pm

I am using an Ultramatch Pro SRC2496 as an Analog to Digital Converter. The setup includes a Allen&Heath MixWizard WZ316:2 feeding an Analog signal from the A/B Out Outputs which are a pair of impedance balanced TRS jacks. I am using TRS to Male XLR Balanced Cables for each jack (Hosa Cable STX110M 1/4 TRS to XLR Male Cable - 10 Foot). These are plugged into the Analog L/R Inputs on the SRC2496. I have setup the SRC2496 to be Analog In. In this setup I am not able to receive any audio signal into the device at all. I have checked the audio coming out of the Mixer with Headphone and that checks out just fine. The LEVEL METER does not register any signal. I am also not able to select any sources using the SOURCE switch and thought this is because there is no signal.

I then come out of the Digital Output with an XLR cable to a Sescom SES-AES-EBU-1 XLRF to 75 Ohm BNC Female AES/EBU Impedance Transformer and then into the AES/BNC audio input on the ATEM TS. I am not getting any audio to the ATEM but I believe the issue is between the mixer and the SRC2496 but just in case I wanted to give the end-to-end connection.


Posts IndexRead Thread 


Current Message Thread:





© 2019 CreativeCOW.net All Rights Reserved
[TOP]