FORUMS: list search recent posts

Re: Cannot Output timecode to tape FCP

COW Forums : Blackmagic Design

VIEW ALL   •   ADD A NEW POST   •   PRINT
Respond to this post   •   Return to posts index   •   Read entire thread


Mark Spano
Re: Cannot Output timecode to tape FCP
on Jul 24, 2012 at 7:16:44 pm

You don't output timecode from FCP. That's not what the serial control is for. The serial control passes timecode information back and forth from the tape deck to FCP.

You need to stripe a bit of code onto the tape before you can achieve an assemble edit from FCP. Once the tape has a small amount of code, you can invoke "Edit To Tape" from FCP and assemble-edit your sequence. ETT allows you to remotely control the tape deck and set an in point where you want the sequence to go on tape. Then you can set an in and out point in the sequence, drag the sequence to the Assemble button in the ETT window, and the deck will automatically preroll and roll in, recording your edit.



Posts IndexRead Thread 


Current Message Thread:





© 2020 CreativeCOW.net All Rights Reserved
[TOP]