AJA Video Systems Forum
Using Downconvert from Kona 2 to SD
Using Downconvert from Kona 2 to SD
by mark pigott on Jun 24, 2008 at 5:20:13 pm

Hi! I'd like to take some XDCAM footage off an XDCAM timeline
in FCP and sent it out to a composite SD DVD recorder by using the
Secondary Downconvert (525i 29.97) on a Kona 2.

Problem is; it seems that it will only output in the three output
video mode and not send out the video as composite.

Are there any tricks to this.




Re: Using Downconvert from Kona 2 to SD
by gary adcock on Jun 24, 2008 at 5:57:42 pm

[mark pigott] "Problem is; it seems that it will only output in the three output
video mode and not send out the video as composite. "


Set the AJA control panel to output via composite and use the "green" component channel for the connection to your deck.




gary adcock
Studio37
HD & Film Consultation
Post and Production Workflows
Inside look at the IoHD





Re: Using Downconvert from Kona 2 to SD
by mark pigott on Jun 24, 2008 at 6:01:53 pm

[gary adcock] "Set the AJA control panel to output via composite and use the "green" component channel for the connection to your deck."

Thanks, after I messaged, I read the manual.

I jumped the gun. All is good.







© CreativeCOW.net