Maxon Cinema 4D Forum
Loop Alembic baked simulation
Loop Alembic baked simulation
by Pedro Oliviera on Nov 1, 2019 at 9:15:27 pm

Hello there,

I'm attempting to loop a simulation in cinema4d. It's basically cloners with a dynamics tag being tossed around by a turbulence force I thought maybe if baked it to alembic and applied it to a motion clip, I could blend both in and out points? But that doesn't seem to work.

Is that possible? I also tried using a pose morph that but not sure it's grabbing the correct information? idk. I'm using R20.

Any input is appreciated!


Re: Loop Alembic baked simulation
by Brian Jones on Nov 2, 2019 at 7:55:51 pm

https://www.youtube.com/watch?v=B4n0TPcPd5E - this was referenced in another thread that offered another solution as well (can't find that thread) so it's not the only way


Re: Loop Alembic baked simulation
by Pedro Oliviera on Nov 4, 2019 at 4:29:10 pm

I tried this method without luck. Either I'm doing something wrong or it doesn't work for this specific way. Not sure tho. Thanks for the reply.





© CreativeCOW.net