Sorry if this has already been answered as I am still new to the forum.
I was filming a product on spinning turntable, lit by two arri 650s, a 300 top light and a 750 fill light. I used a 1DC on 50fps All-I C-Log and varied the shutter speed and ISO keeping at f.8.
Afterwards I noticed a lot of banding issues on the front panel of the product and this was varied on the shutter speed but was not conclusive on which was best. I ranged it from 1/60 to 1/250 as I had read that shooting at 50fps and 1/50 shutter speed would cancel out the frame rate.
Is there anything I can do in camera to stop this banding?