hi just wondering about the behaviour of the view ports in connectfx
so if you have connectfx set as your output life is good, the view port stays at fit (once you select it) but say you want to change it to result view, in other words seeing the result of whatever node or clip you are on, it auto changes back to 100 percent making you select fit again .. this is no good if you you are jumping around a node tree
This is a problem that has been reported to use recently, but we couldn't reproduce. It sounds like a temporary problem. We'll make sure that it is tracked down by our testing department so it can be fixed in a future release.
Flame / Smoke Senior User Experience Designer
Autodesk Media & Entertainment