I think 10.5.3 update killed my Caldigit!
by ian lamb
on
Jun 4, 2008 at 3:32:09 am
Anyone else have the same problem? After updating Leopard, all my media stored on our HDPro glitches all over the place on playback. Copied a few clips to the local storage and playback is fine. Arg.
Re: I think 10.5.3 update killed my Caldigit! by ian lamb on Jun 4, 2008 at 3:51:43 am
Didn't know there was a caldigit forum here... good to know! Just read that first post. I had to re-install FCS2 and ran the usual software upgrade for studio not realizing there was a system software upgrade at the same time. It was probably right in front of my face too..
Re: I think 10.5.3 update killed my Caldigit! by jim kinsey on Jun 4, 2008 at 4:47:58 am
They are working on it and should have a patch this week. I am playing back footage fine but when I go to render FCP 6.0.2 the program hangs and I have to do a hard shutdown. The trick is to only render tiny bits at a time and hit the escape key save and option+r in tiny amounts and save until you are very close to the render being complete.... this doesn't give it time to hang on what Cal digit calls a bad kernal with the new leopard install. This is working for me on the render hangs....
