APPLE FINAL CUT PRO:

How to simulate a blue only in Final Cut


	Cow Forums : Apple Final Cut Pro << PREVIOUS THREAD • VIEW ALL THREADS • PRINT • NEXT THREAD >>

How to simulate a blue only in Final Cut
by Arthur Puig on May 23, 2008 at 6:35:47 pm

Hi,
I have to fix a dead pixel that is only viewable in blue only mode, I can see it in the monitor, but it would be better if I can see that in my canvas, specially when the dead pixel is moving, it gets really hard to track it in the monitor.
So far I tried to use some channel filters but I cannot get to see it as in the monitor

Thanks!

Respond to this post • Return to posts index

Re: How to simulate a blue only in Final Cut
by Michael Sacci on May 23, 2008 at 7:14:17 pm

Effects>Video Filters>Quicktime>RGB Balance

Set Red and Green to (0)

Respond to this post • Return to posts index

Re: How to simulate a blue only in Final Cut
by Jim Carswell on May 23, 2008 at 7:23:18 pm

You can always duplicate one of the pixels on either side of the dead one and move the duplicated one in its place. It's not perfect but it works.
Jim

Jim Carswell
Spyhop Productions, Inc.
Savannah, GA
www.spyhopproductions.com

Respond to this post • Return to posts index

Re: How to simulate a blue only in Final Cut
by Arnie Schlissel on May 23, 2008 at 8:11:17 pm

[Arthur Puig] "specially when the dead pixel is moving"

A dead pixel, by definition, should not move. It should always be in the same place because it will always be the same pixel that's dead.

Arnie

Post production is not an afterthought!
http://www.arniepix.com/

Respond to this post • Return to posts index

Re: How to simulate a blue only in Final Cut
by Scott Thomas on May 25, 2008 at 6:42:07 pm

[Arnie Schlissel] "A dead pixel, by definition, should not move."

Perhaps a camera with image stabilization?

Respond to this post • Return to posts index


	<< PREVIOUS THREAD • VIEW ALL THREADS • PRINT • NEXT THREAD >>