APPLE FINAL CUT PRO:

Timecode´s gone after capture


	Cow Forums : Apple Final Cut Pro << PREVIOUS THREAD • VIEW ALL THREADS • PRINT • NEXT THREAD >>

Timecode´s gone after capture
by Jacob Duus (Jacob duus) on Aug 22, 2008 at 9:59:43 am

Hi Everyone

Wierd Thing. I have 20 captured XDcam-discs, recorded in IMX50 (50i) but captured via Firewire in DV-codec (Don´t ask me why), 5 of the disk have dropped the timecode on every clip (now starting on 00.00.00.00)

There´s no timecode breaks on the discs, and though the audio is recordet in 48Khz, FCP is warning me about different audio samplerate.

I´m in Pal land, so drop frames should not be the issue here.

Any ideas?

Setup: Imac 24" 3.02, 4Gb ram - FCP 6.0.4 -2TB Stardom disk raid

Respond to this post • Return to posts index

Re: Timecode´s gone after capture
by Jamie Pickell on Aug 22, 2008 at 5:30:59 pm

Jacob,

I had a similar problem when I upgraded from FCP 5 to 5.1. I digitized via Kona 2 from DBeta and then the timecode would reset to zero on the clips. I ended up trashing the preferences and that stopped the problem from happening again.

Hope that helps,

Jamie

FCP 6.04
OS 10.4.11
Kona 2
XRaid
Dual 2.5 G5 (Intel hopefully coming soon...)

Respond to this post • Return to posts index

Re: Timecode´s gone after capture
by Charles Taylor on Aug 26, 2008 at 7:09:02 pm

I have intermittently run up against this problem digitizing all kinds of stuff.

My solution has been to cry a little, and then digitize it again. That usually works.

AFAIK, its just FCP being stupid.

Respond to this post • Return to posts index


	<< PREVIOUS THREAD • VIEW ALL THREADS • PRINT • NEXT THREAD >>