SHIMERING IN FCP AFTER COLOR GRADING
by David Cape
on
Jul 13, 2008 at 2:08:50 pm
I have graded a short doc 175 clips 23 minutes, DVC PRO HD 720P. After render the sequence was sent back to FCP. A single grade was used for 4 clips of an interview. In one of these clips in FCP a kind of shimering was noticed. In Color this shimering was not apparent. Is it possible to return to Color and tweak this color grade?
Any thoughts would be greatly appreciated and I thank you.
Re: SHIMERING IN FCP AFTER COLOR GRADING by walter biscardi on Jul 13, 2008 at 2:18:26 pm
The shimmering wouldn't be apparent since you can't properly watch your clip in full, uncompressed realtime quality in Color.
Just go back to Color, tweak that one shot, Add that shot to the Render Queue and re-render. As long as you don't change the Grade number, it will render right over the original clip. After it's done, dave the project, quit Color and launch FCP.
FCP will see the newly replaced shot.
[David Cape]" In Color this shimering was not apparent"
Walter Biscardi, Jr.
Biscardi Creative Media HD and SD Production for Broadcast and Independent Productions.
Re: SHIMERING IN FCP AFTER COLOR GRADING by Floh Peters on Jul 13, 2008 at 2:19:35 pm
Just reopen your Color project (do NOT use a "send to Color again). Change your settings for the correction and rerender. Assuming you havenīt changed anything else you should see the updates in FCP after rendering.
