Pan & Zoom problem with cross dissolve
by Lucas Young
on
Nov 2, 2009 at 3:30:43 am
Hi guys
I'm using the Pan and Zoom (advanced) freebie plugin from the site to get the Ken Burns effect happening on a sequence of photos. The plugin only works on one photo at a time. If I line up two photos next to each other using this plugin, and try and cross dissolve between them, there is a slight "jump" (i.e. a slight zoom out) when the playhead hits the edge of the cross dissolve. How can I dissolve between clips using this plugin?
Re: Pan & Zoom problem with cross dissolve by Gabriele de Simone on Nov 2, 2009 at 1:35:26 pm
Hi Lucas,
The generator shouldn't act any differently than other clips for the purpose of adding a transition. Perhaps there are other settings (motion, geometry) that are causing the unwanted pop.
Please contact us on Tech Support, we could try to replicate your sequence settings and build a sample project for you.
Re: Pan & Zoom problem with cross dissolve by Mark Block on Nov 19, 2009 at 11:09:11 pm
I downloaded Pan & Zoom yesterday to try it out. Got the same problem. Whether it was a plain dissolve or FX Factories transitions, there was a bump at the start and end. Tried trimming both sides back, but always got a mismatched frame at the transition.
