error when trying to burn a DL
by Thomas Hughes
on
Mar 18, 2008 at 11:03:26 pm
When burning a DVD+R DL disc, DVD studio is continually returning an error #6 message. We have set it to burn a dual layer with the DVD Studio presets in place. The disc is then useless as info is written but not completed nor formatted, why is this?
Re: error when trying to burn a DL by del chapple on Mar 19, 2008 at 6:40:04 pm
not sure what error 6 is but. in the past when doing a DL disc DVDSP has given me problems by not placing the DL break point properly, if you do not tell it where the break point is and leave it on auto, it'll use one of you existing markers in the timeline which ,in my case, were to far apart. Layer 0 has to be bigger than Layer 1. Its somewhat trial and error or just try and do the math and figure out where in the timeline a little over center is, remember to include menus etc in the calculation..
