A/V Out-of-Sync
by Samuel Boulton
on
Jun 12, 2008 at 2:40:10 pm
I converted a VOB file using Studio 11P. to a MPEG2 file. Then I imported the mpeg2 file into the AL7.2 program application. I completed some minor editing, added an AVI file in the front and in the back of the imported file (clip). Then I added a menu between the first avi clip and the imported clip (mpeg2). The completed project runs fine and behaves properly inside the program application using the onboard DVD editor, preview tab.
I then outputted the completed file using: DVD Direct-to-disk.
The output DVD plays fine, looks good and behaves properly in my home DVD player. But several spots on the DVD have very noticeable A/V out-of-sync problems. I repeated my steps, tried different edit presets (slowing down the bitrates), but the results are always the same. Any suggestions would be greatly appreciated.
Re: A/V Out-of-Sync by Lew Schatzer on Jun 12, 2008 at 5:31:35 pm
Try fusing the imported mpeg file from the VOB to an AVI file. Check that the AVI file is in sync, then use that to make your DVD instead of the mpeg file.
