FCS 3 and multibridge drivers questions.
by Harold Chlewicki
on
Oct 19, 2009 at 3:16:55 pm
Hi everybody,
So I'm upgrading to Final Cut Studio 3 (Thanks to a client :( )
My actual installation is :
Mac OS 10.5.8
Final Cut 6.0.6
Multibridge drivers : 7.1.2
Hardware : Multibridge Pro 2
I have some silly questions since it's been a while I didn't upgrade :
(Just so you know, I don't want to go Snow Leopard for the moment, I want to stick with 10.5.8)
- Can I go directly to the 7.3.2 drivers after I installed FCS3 ?
Or should I go through all the previous drivers before installing the last drivers version ?
-Do we agree that I have to switch my multibridge OFF during all the process and then Switch it ON after I upgraded FCS and the multibridge drivers ?
Re: FCS 3 and multibridge drivers questions. by Kristian Lam on Oct 20, 2009 at 2:43:53 am
Hi Harold,
[Harold Chlewicki]"- Can I go directly to the 7.3.2 drivers after I installed FCS3 ?
"
Yes, you can go directly as all our drivers are standalone.
[Harold Chlewicki]"-Do we agree that I have to switch my multibridge OFF during all the process and then Switch it ON after I upgraded FCS and the multibridge drivers ?
"
No, leave the Multibridge on as there may be firmware updates to apply to the Multibridge. However, there will be a need to power cycle the Multibridge and you'll be prompted to do so by the installation software.
