PANASONIC VARICAM:

HDX 900 Bat settings


	Cow Forums : Panasonic VariCam << PREVIOUS THREAD • VIEW ALL THREADS • PRINT • NEXT THREAD >>

HDX 900 Bat settings
by Robin Probyn (Redflag) on Sep 24, 2008 at 11:58:13 am

Not sure what to set as full setting for iDX elite bat,in HDX900 bat set up HDX900 camera menu.

manual says 16.8V nominal voltage 14.8V

Goodman guide says important to get these settings right,for battery running time..

Thanks

Respond to this post • Return to posts index

Re: HDX 900 Bat settings
by Robin Probyn on Sep 26, 2008 at 12:19:38 am

I heard its the same setting as IDX Endura 10

Respond to this post • Return to posts index

Re: HDX 900 Bat settings
by Ray Palmer on Sep 29, 2008 at 9:23:12 pm

I don't ownn any IDX batteries. I did just go on the Internet and saw that they were running 14.2 volts for some of them.

I believe that the battery setting on the camera is to show you when you have a low battery. You should be able to see if your batteries are running 14.2, 14.4 or above.
Typically the cameras like to run at 12 volts. The original PB90 batteries were rated at 12 volts but when they were "loaded" the voltage dropped below 12 volts. That is why AB and others run at 14.4 so when loaded down with lights and camera, the battery is still well above 12 volts.

Ray Palmer, Engineer
Salt River Project
Phoenix, AZ
602-236-8224 office
There are three types of people in this world, those that can count and those that can't.

Respond to this post • Return to posts index

Re: HDX 900 Bat settings
by Robin Probyn on Sep 30, 2008 at 2:48:16 am

Ok thanks for the info

Respond to this post • Return to posts index


	<< PREVIOUS THREAD • VIEW ALL THREADS • PRINT • NEXT THREAD >>