Re: AJA Xena and DVCPRO (IEEE1394)

And a few more questions/possible solutions to add to the ones above:

1. What are your device control settings:
Capture, handles, etc in PPro
2. Is this an EDL or hand logged batch capture?
3. Is it repeatable (i.e. will it always happen with a certain batch list)
4. Is the first clip you caputre at beginning of the tape?
5. Does this happen when doing a single log and capture with the same in/out times and tape?
6. Can you capture video/audio(with same Capture setup) via a crash capture over the same in/out times in which he sees a crash with batch?
7. Try turning off Embedded SDI VITC and enabling Embedded SDI LTC on the deck (it is a menu setting setup in the deck) and then try a batch capture using embedded SDI (must be setup as both TC Input in Xena Capture Settings menu and via a check box in the Xena device control settings menu)
- Embedded SDI LTC should work (but not embedded VITC)
8. Also, is the timecode on all your tapes completely continuous? Did you stripe them before you used them?

AJA XENA Support