Re: Annoying LatheNURBS 'seam'


	Cow Forums : Cinema 4D VIEW POSTS • ADD A NEW POST • SEARCH • CHANGE FORUM

Respond to this post • Return to posts index • Read entire thread

Re: Annoying LatheNURBS 'seam'
by graham proctor on Oct 22, 2009 at 9:19:37 am

Hi Brian,

Thanks for this. It's the movement. How dumb of me. Just before I dropped the spline on to the LN i had been fooling about with the parameters using another spline. Rather than start a fresh I just used the existing LN. There was a movement value of 1 - which was sufficient to create a 'ghosted seam' - but not enough to draw my attention to anything obvious in the geometry (i.e a visible edge/break).

Thanks again for this. Maybe I should get out a bit more often...

All the best,

Graham

Respond to this post • Return to posts index • Read entire thread

Current Message Thread:

Annoying LatheNURBS 'seam' by graham proctor on Oct 21, 2009 at 9:54:04 pm
- Re: Annoying LatheNURBS 'seam' by Brian Jones on Oct 21, 2009 at 10:03:25 pm
  - Re: Annoying LatheNURBS 'seam' by graham proctor on Oct 22, 2009 at 9:19:37 am

Note: If you are a registered user please click here to login before posting.

Your post will not be accepted if your name and email address are not registered in our database. Click here if you do not have an account.

Name

E-Mail Address

Subject

E-Mail me when someone responds

Just This Message

Entire Thread

None

Message:

Note: The following are HTML characters and may cause parts of your post to disappear if not used correctly: < > &
To include any portion of the post in your response, highlight the desired text and hit the "Q" key. Read more...

Add your message signature

Note: By clicking "Post Direct" button above, you are agreeing to the Creative Cow's Code of Conduct.