Re: Wanting your feedback on our drivers

Vizio input on 720p HDMI is pink/green/purple on HDMI. But all fine on component. It's also low rez. The pixels are extremely stair stepped. But, I just have it set to uprez everything to 1080 so it really isn't an issue in my workflow. Used to be because the mini didn't always uprez 720 to 1080 AND output a center cut SD signal at the same time. At some point that feature was added. Pretty amazing really. This has been a known issue for some time and I figured ya'll just cut your losses. It only occurs on older Vizios and the blame was placed on Vizio for having some non-standard HDMI. But it works fine with every other 720p peripheral I have.I have a newer Vizio that doesn't exhibit the behavior with it.

The 24p was some Canon 5D material shot at 1080p24 in FCP X. The material aside, I can't get it to output 24hz to the Vizio. With everything set to 24p in X and the system panel, it still outputs 30hz. In FCP 7 the monitor gets a 24hz signal. Ditto with BlackMagic drivers. Perhaps for now you're just adding pulldown?

I only have CS5. But I have downloaded the trial of CS5.5 on the MacPro and had the same result. Haven't tried CS5.5 on my iMac. But CS5 is the same. Usually dealing with 1080p masters, but it could be any flavor of HD. Almost always ProRes 422. I've tried bringing in FCP 7 XMLs to Premiere and copying and pasting the sequence content into a Matrox Sequence preset so that it works out the Matrox. Which it does, for a few minutes and then gets overwhelmed and just stops.